Safety rated multimeters with mA source.
Now process technicians can do a lot more while carrying a lot less. The ultimate loop calibration multimeter – the Fluke 789
ProcessMeter. The Fluke 789
ProcessMeter was the first tool to combine a loop calibrator with a DMM
to give process technicians double the power in one tool.
The Fluke 789 has a display that’s not only twice as large, but also twice
as bright with two levels of backlighting.The Fluke 789 has a 24-Volt loop supply reducing the need for taking a separate power supply when doing offline transmitter testing. And with its built-in, selectable 250-Ohm Hart® resistor, it also eliminates the need to carry a separate resistor with you.
For a lower price look at the
Fluke 787 ProcessMeter
What's Included:
- Fluke TL71 Premium Safety-Designed Test Lead Set plus alligator clips
- Four AA alkaline batteries (installed)
- Product overview and users manual (CD-ROM) in 14 languages
- 24 V Loop power supply
- Double-sized, dual display
- Enhanced backlight with 2 brightness settings
- 20mA drive into 1200 ohms
- HART mode setting with loop power (adds 250 ohm resistor)
- 0% and 100 % mA Span Check buttons to toggle between 4 and 20 mA
- Externally accessible fuses for easy replacement
- Infrared I/O serial port compatible with FlukeView Forms software
- Precision 1000 V, 440 mA True-RMS digital Multimeter
- 0.1% dc voltage accuracy
- 0.05% dc current accuracy
- Frequency measurement to 20 kHz
- Min/Max/Average/Hold/Relative modes
- Diode Test and Continuity Beeper
- Simultaneous mA and % of scale readout
- 20 mA DC current source / loop calibrator / simulator
- Manual Step (100%, 25%, Coarse, Fine) plus Auto Step and Auto Ramp
- Improved battery power with four AA batteries
Safety Conformance
Meets 1000 Volt EN61010-1 CAT III standards and 600 Volt EN61010-1 CAT IV standards.
No user reviews available.
USD (change) 
